7/10/2023 0 Comments Blueprint title block templateA good minimum text size is 3/32″ (2.4 mm) high, or better yet 1/8″ (3.2 mm) high. Again, this is important information, and paper sets are often printed at half-size, so it’s good to avoid extremely small text. The title block text should generally be larger in size. It should be designed to make the remaining “work area” of the sheet as usable as possible for the type of work shown. It should not take up more “real estate” than is necessary. The “information table” part of the title block should be as compact as possible while still being easy to read. It helps the reader of the drawings to quickly locate the right sheet with the right information. The title block should be easy to see and read when you’re quickly rifling through a bound set of prints. This is helpful when discussing a drawing by phone. This “forces” the drawing author to keep the objects out of the “staple zone.”Some borders contain rulers (see the image above) with numbers or letters, to help locate a specific item by its coordinates. The border line along the left edge of the sheet should be given a wider margin if the binding is to go along the left edge. Sheets with no border around all sides are much more likely to be printed and bound out of alignment. The border around all four edges of the page is helpful in making sure that the paper prints (I know, I’m dating myself here) are printed properly. It may or may not include a border, as discussed above. Or it may only occupy a generally box-shaped area in the lower right corner.Ī title block with an attached revision block From there it may extend along the right edge to the top right corner, or across the bottom edge to the lower left corner. The title block information table is typically located in the lower right corner of the sheet.
0 Comments
Leave a Reply. |